top of page
Search
• Shawn P

Tired of tripping your 15 amp Circuit Breaker?

A 15 amp 120v circuit is a common type of electrical circuit found in most homes. It is rated for 15 amps of electrical current and operates at a voltage of 120v. This type of circuit is typically used to power lights and outlets in a single room or area of a home.

The number of things that a person can plug into a 15 amp 120v circuit depends on the wattage of the devices being used. The wattage is a measure of the electrical power consumed by a device and is typically printed on the device or its packaging.

To calculate the total wattage of the devices being used on a 15 amp 120v circuit, you simply add up the wattage of each device. For example, if you have three 100 watt light bulbs, a 300 watt coffee maker, and a 500 watt television, the total wattage would be 900 watts (100 x 3 + 300 + 500 = 900).

It's important to note that the wattage of a device can vary depending on how it is being used. For example, a 100 watt light bulb may consume less power when it is turned on at a low setting compared to when it is turned on at a high setting.

In general, a 15 amp 120v circuit can safely power devices with a total wattage of up to 1,800 watts (15 amps x 120 volts = 1,800 watt). This means that in the example above, the circuit would be able to safely power the three light bulbs, coffee maker, and television because the total wattage of the devices is 900 watts, which is well below the 1,800 watt limit.

However, it's important to not exceed the wattage limit of a circuit to avoid overloading it, which can cause damage to the circuit and potentially create a fire hazard. It's always a good idea to check the wattage of the devices you're using and make sure that the total wattage is within the limits of the circuit.

In summary, a 15 amp 120v circuit can power a number of devices, but the total wattage of those devices should not exceed 1,800 watts to avoid overloading the circuit. It's important to always check the wattage of the devices you're using and make sure they are within the limits of the circuit.